156 results found.
Year: 2015, Volume: 15, Number: 3
... the linear induction motor drive applications [4-7]. The main LIM, which can be directly used in vector control idea behind IFOC in an LIM is the decoupling of the flux applications, has become an indispensable challenge for the and the torque. The flux orientation can be achieved by researches. The simplest method to ...
Terms matched: 1 - Score: 3 - 1,163k
Year: 2015, Volume: 15, Number: 2
... MATLAB simulation. The proposed system has 50 to 60 conditions. Ambimax [5] does MPP tracking autonomously percent improved conversion efficiency when compared to the conventional direct coupling method. The parameters of the and charges supercapacitors at maximum efficiency. It uses photovoltaic panel model have been validated through 70 mAh Li-Polymer battery and two 10 ...
Terms matched: 1 - Score: 11 - 953k
Year: 2015, Volume: 15, Number: 2
... with variable number [5] B. Mohajer-Iravani, S. Shahparnia, "Coupling reduction in enclosures of grounding vias," Proc. of the Fourth European ... June 2005. [Online]. Available: solutions on package and PCB: decoupling and EBG isolation", IEEE http://dx.doi.org/ 10.1109/ ...
Terms matched: 2 - Score: 5 - 1,023k
Year: 2015, Volume: 15, Number: 1
... , the most important information is that a digitization (A /D conversion) always uses filters, amplifiers, classical multifunctional filter requires a change of the input coupling blocks with defined bandwidth, etc. However, chip or output in structure to obtain different transfer development is very expensive and, unfortunately, also the characteristic ...
Terms matched: 1 - Score: 3 - 1,058k
Year: 2015, Volume: 15, Number: 1
... Assur, vol [14] J. Bhattacharya, E. Pereda, H. Petsche, "Effective Detection of 7: pp.242 – 249, 2002. Coupling in Short and Noisy Bivariate Data," IEEE Transactions on [26] G. Meinrath, P. Spitzer, "Uncertainties in Determination of pH, ...
Terms matched: 1 - Score: 3 - 951k
Year: 2015, Volume: 15, Number: 1
... on the maximum Euclidean recommended in fault-tolerant machines. In addition, the distance to the origin point. To increase the accuracy of the design should ensure low mutual coupling among phases to AFPM design, a further refinement loop is applied, in which limit the effect of the short circuit in one phase on other the air ...
Terms matched: 1 - Score: 3 - 1,186k
Year: 2014, Volume: 14, Number: 4
... are j ..  2.0 p Nj 2 2 connected mechanically by a coupling. i wi  1  (23) 20 where i is generation ... coordinate system (x, y). I. INTRODUCTION In reference to simple decoupling between individual The electrical drive is a basic element of electrical energy magnetizing and ...
Terms matched: 2 - Score: 13 - 871k
Year: 2014, Volume: 14, Number: 3
... (DYN);- Magtrol brake controller DSP-6001 (CONTR) As it had been expected (Fig. 6, 7), there are commutation- Motor coupling system (CS); over-voltages in the range of about 50% from supply- Motor fixing system (Fig. 4); amplitude, but over-voltages ...
Terms matched: 1 - Score: 6 - 956k
Year: 2014, Volume: 14, Number: 3
... , to determine machine heating (of winding and ferromagnetic cores) should be regarded as any artificial testing. An advantage of this method is the lack of mechanical coupling with a machine of the same power and speed. This advantage becomes important for induction machines with vertical axis. c1) Characteristic m(t) -detail ...
Terms matched: 1 - Score: 3 - 718k
Year: 2014, Volume: 14, Number: 3
... and in order to better optimize the code communication between phases must be improved. III. COMPILER FRAMEWORK DESCRIPTION It is observed in [5-6] that this phase coupling is especially A. The baseline compiler description important in relation of instruction selection, register Several key elements of the baseline compiler are allocation, and instruction scheduling ...
Terms matched: 1 - Score: 25 - 1,054k