264 results found.
Year: 2013, Volume: 13, Number: 3
... identify massive simulation experiments have fully proven that the system faults. fault identification can be performed successfully by Index ... Computer Engineering Volume 13, Number 3, 2013 New Fault Discrimination under the Influence of Rayleigh Noise Yagang ZHANG ... and seeking after for the uniform laws of category and non-fault category will be explored. In the electrical quantities ...
Terms matched: 4 - Score: 226 - 632k
Year: 2013, Volume: 13, Number: 3
... in the Linux kernel is Scheduler (CFS) [18-19]. The general Linux kernel as its an integer number between 0 to 139. The priority number default scheduler employs this scheduler. Thus, it is also from 0 to 99 are reserved for real-time class tasks. Tasks used in OSs for PCs and even ...
Terms matched: 1 - Score: 15 - 929k
Year: 2013, Volume: 13, Number: 2
... can substitute another consideration of the abnormal comportments and the faults failed equipment or element, one can speak about ... uses converters must be realized by using high reliability the fault tree method. Based on the symptoms observed in ... ", Advances in Electrical and Computer Engineering Topology With Fault-Tolerant Ability", IEEE Trans. Power Volume 12 ...
Terms matched: 4 - Score: 268 - 716k
Year: 2013, Volume: 13, Number: 2
... of cryptographic algorithms [17]. Further then the transmitter can send up to 50 blocks per second. on, some solutions incorporate a very complicated With a default block size of 512 bytes, the transfer rate is authentication system that uses a time synchronization bounded to 25 kB/s [1 ][ 10] ...
Terms matched: 1 - Score: 3 - 908k
Year: 2013, Volume: 13, Number: 1
... . However, the weak at this situation. Therefore small error in the difference between the results begins to increase along with calibration of the torque transducer can cause faulty in the the increase of the current value. In FE simulations, B-H measurements, especially at low torque conditions. 79 Advances in Electrical and Computer Engineering ...
Terms matched: 1 - Score: 3 - 649k
Year: 2012, Volume: 12, Number: 4
... many times assumed in three-phase power systems. In tested during the cold war, they can estimate a parameter of reality, most voltage dips occur due to unbalanced faults, interest one-step-ahead based on the previously observed which introduce different values of voltage for each phase values. Two filters are implemented. Their performance is and phase ...
Terms matched: 1 - Score: 3 - 794k
Year: 2012, Volume: 12, Number: 4
... ), Volume 206/ 2011, Part 7, [6] M. Merah, A. Ouamri, A. Nait-Ali, M. Keche, "Fault Tolerant Neural pag. 481-487, Springer-Verlag Berlin Heidelberg 2011, Network for ECG Signal Classification Systems", Advances in [24] G. Antoniol, P ...
Terms matched: 1 - Score: 3 - 608k
Year: 2012, Volume: 12, Number: 4
... basic premises that should guide the design of overcurrent earth faults [15]. Finally, Wiles [16 ... electrical faults that may pose a risk to PVG because fault protection in order to reduce fire risk. For ... to were specifically conceived for alternating current low voltage simulate faulty conditions, in a specific PVG [20-25] ...
Terms matched: 7 - Score: 3313 - 1,891k
Year: 2012, Volume: 12, Number: 4
... , Number 4, 2012 A Novel Method for Inverter Faults Detection and Diagnosis in PMSM Drives of HEVs based ... Motors (PMSM) of Hybrid Electric Vehicles. The fault behaviour of the analyzed system was simulated by [ ... switch is short-circuited, calculation of the current-vector trajectory, faulty transistors its phase leg is directly connected to the ...
Terms matched: 4 - Score: 346 - 1,013k
Year: 2012, Volume: 12, Number: 3
... time domain adaptive taking into account the nonlinearities in the system. simulations for different faults and various operating On the other hand, nonlinear adaptive control techniques conditions of ... 24) ‚ ij j ƒ j - j € i € ij fault is applied at middle of one of the lines connecting bus- j 4 ...
Terms matched: 2 - Score: 36 - 792k