264 results found.
Year: 2019, Volume: 19, Number: 4
... open- of switches S1 and S2, respectively. The secondary side of circuit faults that will definitely damage converters. In [22], the coupled-inductor with ... X. Pei, S. Nie, Y. Kang, "Switch short-circuit fault diagnosis and remedial strategy for full-bridge DC €“ DC converters," IEEE concluded ...
Terms matched: 2 - Score: 3 - 1,060k
Year: 2019, Volume: 19, Number: 4
... overload, inrush currents, Power Analyzer geomagnetically induced currents (GIC) and other faults [2- 6]. In the above situations, there will be ... Primary Secondary be damaged, which results in a more serious short circuit winding winding fault and permanent destruction of transformers and inductors. Exitation L winding A In order ...
Terms matched: 2 - Score: 8 - 423k
Year: 2019, Volume: 19, Number: 4
... L. Parsa, "Thrust optimization of a five-phase fault- [22] N. Ullah, A ... "Design and analysis (mWb) of a new fault-tolerant linear permanent-magnet motor for maglev transportation applications," ... mover topology having same design characteristics of a novel six-phase fault-torrent linear permanent dimensions with a valid selection of dual ...
Terms matched: 3 - Score: 10 - 798k
Year: 2020, Volume: 20, Number: 2
... 10.1049/iet-epa.2016.0490 2007. doi:10.1109/TMAG.2006.888811 [32] J. Cai, Z. Liu, Y. Zeng, "Aligned position estimation based fault- [17] C. Hudson, N. Lobo, R. Krishnan, "Sensorless control of single tolerant sensorless control strategy for SRM drives, ...
Terms matched: 1 - Score: 3 - 1,647k
Year: 2020, Volume: 20, Number: 2
... = 12, sample spacing= 16, control point important to perform gradient non-linearity correction for spacing= 64, spline stiffness= 0.0001 and cuboid shape is decreasing faults in longitudinal behavior response selected for ROI. procedures. If it is ignored, gradient non-linearity (GNL) 2. Segmentation and Feature Set Construction: manifests ...
Terms matched: 1 - Score: 3 - 1,432k
Year: 2020, Volume: 20, Number: 2
... [23], a heuristic algorithm based network infrastructure with high transmission capacity. on Integer Linear Programming (ILP [24] is proposed to OTN also provides fault isolation management with solve the routing problem in the OTN/DWDM networks advanced techniques for solving any operational issues [4]. context. The application involves ...
Terms matched: 1 - Score: 3 - 1,360k
Year: 2020, Volume: 20, Number: 2
... L € (22) to (27). In the case of multiple repetitions for the largest searched pattern, the closest one should be taken as default where L € i € € n € L € 1€. repeat. Therefore, scanning routine should be from closer The sample in the infinite history, ...
Terms matched: 1 - Score: 8 - 2,045k
Year: 2020, Volume: 20, Number: 1
... no W satisfies this requirement, ROI is simply The remaining three indices are used to evaluate the mapped to the centre of the image, which is also a default performance of the proposed ROI search scheme. In this ROI location. case, PSNR is calculated as follows [30]: IV. TEST IMAGES ƒ ...
Terms matched: 1 - Score: 31 - 840k
Year: 2020, Volume: 20, Number: 1
... performed in a single processor cycle, as an atomic CSR address convention uses the CSR address bits to operation. The real-time event handling module uses a encode the default access privileges. number of grSRFi global registers to compose the Signals Register File (SRF). TABLE I. THE IMPLEMENTATION OF THE MRF GLOBAL REGISTERS AND ...
Terms matched: 1 - Score: 3 - 966k
Year: 2020, Volume: 20, Number: 1
... mechanical and electrical tested on three transformers, which have been in the field for faults. Also, transformer faults could be due to insulation several years. This ... Advances in Electrical and Computer Engineering Volume 20, Number 1, 2020 When a fault occurs in a transformer, the inductance and capacitance will change as well, ...
Terms matched: 2 - Score: 15 - 625k