SEARCH THE JOURNAL CONTENT
Enter one or more keywords to search for.
For exact phrase matching use quotation marks (e.g. "speed controller").
Note that '*' and '?' wildcards are supported.
Search results for: load
543 results found.
55 pages of results.
Sorted by relevance / Sort by date
Year: 2017, Volume: 17, Number: 1
... bands in loads. The proposed controller parameter-tuning procedure is based on the three-phase back-EMF-type load, which [3-4] that can partially solve this problem. corresponds to ... (VSI) nonidealities and by nonlinear controllers are proposed with adaptive hysteresis bands in loads. The proposed controller parameter-tuning procedure is based on the three-phase back-EMF-type load, ...
182. Investigation on Performance of Controllers for Three Level PFC Converter for Wide Operating Range
Year: 2020, Volume: 20, Number: 1
... ensures better dynamic performance for line provide effective power conversion with good operating variations and load variations [11]. Output voltage can be performance. This paper deals ... 150 V) for PID controller. From this figure, it is inferred light loading conditions, the output response has that output voltage is severely affected by sudden ...
Year: 2007, Volume: 7, Issue: 2
... below the average and the cvasipeak Mains filters are tested with a 50Ω source and load values, according to the standard in the frequency range of impedance because most ... kW), installed in the houses of the village, presented since connected electrical loads can present virtually any RF malfunctions, and gave error messages on the interface ...
Year: 2011, Volume: 11, Number: 1
... Electrical and Computer Engineering Volume 11, Number 1, 2011 The Impact of the Load Side Parameters on PC Cluster's Harmonics Emission Vladimir A. KATIĆ1, Saša V ... certain number of PCs in a cluster the THDI=f (NPC) power loads are regulated with several standards or line cease to decrease and becomes constant, ...
Year: 2019, Volume: 19, Number: 4
... Abstract — A solution strategy is presented using a five- A match for real load at three independent frequencies using section transmission line impedance transformer aiming for stubbed coupling ... alternative can be the application of shunt stub matching three distinct frequencies especially for complex loads technique. which is very difficult to attain. As a further contribution, ...
Year: 2020, Volume: 20, Number: 4
... Advances in Electrical and Computer Engineering Volume 20, Number 4, 2020 Multi-objective Environmental-economic Load Dispatch Considering Generator Constraints and Wind Power Using Improved Multi-objective Particle Swarm Optimization Tankut ... employ both functional inertia weight and On the other hand, if the valve point loading effects are functional constriction factor. When selecting the text considered in the fuel ...
Year: 2012, Volume: 12, Number: 2
... and Ï„ depend on the So, combustion efficiency increases with rising of bed boiler load (Table I), while the recommended value of the temperature by providing ... its important for decreasing these emissions and increasing the performances are compared at different boiler loads with those combustion efficiency [13]. of a Fuzzy Logic (FL ...
Year: 2018, Volume: 18, Number: 2
... to exhibit high bandwidth-delay HBDP networks [11-13]. They can guarantee not only load product (HBDP) characteristics but MPTCP does not match balancing but also friendliness ... the friendliness with single-path TCP and provide concurrent use of multiple available paths for data loading balancing by controlling increment of congestion transmission, in a manner that is transparent ...
Year: 2014, Volume: 14, Number: 4
... centric DG planning model for The traditional distribution system planning is aimed at voltage dependent load. It is observed that DG planning is the least cost scenario for fulfilling ... , loss reduction, IEEE 33-bus system. Proposed model helps the Distribution maximizing MVA loading and emission reduction is Network Operators (DNOs) to decide the proper DG ...
Year: 2017, Volume: 17, Number: 4
... it is MATLAB/ Simulink environment. also caused by switched mode loads on the load side. Five level cascaded H-bridge based voltage source Therefore the WECS are different ... , the reactive power compensation is done by order to connect the WECS to electrical loads, interfacing examining structure of the D-STATCOM in the network- devices such as ...
Search took 0.274 seconds
The search engine database includes all papers published after 2007, including titles, author names, abstracts, keywords, full papers text, references and citations. For papers published between 2001 and 2006, please visit the Archive section.
We invite you to try the most frequently used search terms:
system - power - control - fault - network - load - model - frequency - converter - transformer - harmonic - computer - algorithm - cancer - simulation - computer - estimate - optimal control - expert system - electromagnetic - interference - data transmission - neural network - electrocardiogram signal - model - cluster - design - wavelet - antenna - wireless sensor - coupling - robust - noise - signal processing - system identification - translation - nonlinear systems - induction motor - speed controller - shape optimization - fuzzy network - wireless sensor network