562 results found.
Year: 2011, Volume: 11, Number: 1
... Electrical and Computer Engineering Volume 11, Number 1, 2011 The Impact of the Load Side Parameters on PC Cluster's Harmonics Emission Vladimir A. KATIĆ1, Saša V ... certain number of PCs in a cluster the THDI=f (NPC) power loads are regulated with several standards or line cease to decrease and becomes constant, ...
Terms matched: 2 - Score: 84 - 851k
Year: 2007, Volume: 7, Issue: 2
... below the average and the cvasipeak Mains filters are tested with a 50Ω source and load values, according to the standard in the frequency range of impedance because most ... kW), installed in the houses of the village, presented since connected electrical loads can present virtually any RF malfunctions, and gave error messages on the interface ...
Terms matched: 2 - Score: 84 - 349k
Year: 2020, Volume: 20, Number: 1
... ensures better dynamic performance for line provide effective power conversion with good operating variations and load variations [11]. Output voltage can be performance. This paper deals ... 150 V) for PID controller. From this figure, it is inferred light loading conditions, the output response has that output voltage is severely affected by sudden ...
Terms matched: 2 - Score: 84 - 787k
Year: 2019, Volume: 19, Number: 4
... Abstract — A solution strategy is presented using a five- A match for real load at three independent frequencies using section transmission line impedance transformer aiming for stubbed coupling ... alternative can be the application of shunt stub matching three distinct frequencies especially for complex loads technique. which is very difficult to attain. As a further contribution, ...
Terms matched: 2 - Score: 83 - 745k
Year: 2020, Volume: 20, Number: 4
... Advances in Electrical and Computer Engineering Volume 20, Number 4, 2020 Multi-objective Environmental-economic Load Dispatch Considering Generator Constraints and Wind Power Using Improved Multi-objective Particle Swarm Optimization Tankut ... employ both functional inertia weight and On the other hand, if the valve point loading effects are functional constriction factor. When selecting the text considered in the fuel ...
Terms matched: 2 - Score: 82 - 1,225k
Year: 2012, Volume: 12, Number: 2
... and Ï„ depend on the So, combustion efficiency increases with rising of bed boiler load (Table I), while the recommended value of the temperature by providing ... its important for decreasing these emissions and increasing the performances are compared at different boiler loads with those combustion efficiency [13]. of a Fuzzy Logic (FL ...
Terms matched: 2 - Score: 81 - 984k
Year: 2018, Volume: 18, Number: 2
... to exhibit high bandwidth-delay HBDP networks [11-13]. They can guarantee not only load product (HBDP) characteristics but MPTCP does not match balancing but also friendliness ... the friendliness with single-path TCP and provide concurrent use of multiple available paths for data loading balancing by controlling increment of congestion transmission, in a manner that is transparent ...
Terms matched: 2 - Score: 73 - 1,620k
Year: 2014, Volume: 14, Number: 4
... centric DG planning model for The traditional distribution system planning is aimed at voltage dependent load. It is observed that DG planning is the least cost scenario for fulfilling ... , loss reduction, IEEE 33-bus system. Proposed model helps the Distribution maximizing MVA loading and emission reduction is Network Operators (DNOs) to decide the proper DG ...
Terms matched: 2 - Score: 72 - 818k
Year: 2017, Volume: 17, Number: 4
... it is MATLAB/ Simulink environment. also caused by switched mode loads on the load side. Five level cascaded H-bridge based voltage source Therefore the WECS are different ... , the reactive power compensation is done by order to connect the WECS to electrical loads, interfacing examining structure of the D-STATCOM in the network- devices such as ...
Terms matched: 2 - Score: 67 - 4,305k
Year: 2019, Volume: 19, Number: 2
... system performance. PSO optimized PID controllers are hybrid MG system during intermittent conditions of load and used in D-FACTS. generation. In addition, a comparative study of ... optimization, particle swarm optimization (PSO) and experimental validation is made using pulsed loads. A grid the PSO with new update mechanism (PSOd) are used ...
Terms matched: 2 - Score: 67 - 1,471k