584 results found.
Year: 2008, Volume: 8, Issue: 2
... out by the change of variable [4] http://ww1.microchip.com/downloads/en/DeviceDoc/39564c.pdf [5] http://datasheets.maxim-ic.com ... exact setting varicap is used. [6] http://www.analog.com/UploadedFiles/Data_Sheets/ref9Xseries.pdf Such method allows to decrease substantially dependence of 31 ...
Terms matched: 2 - Score: 21 - 474k
Year: 2019, Volume: 19, Number: 1
... this circuit in comparison with the one shown in Fig. 4: the maximum load current can be increased by roughly 50mA by simply setting the IQlimit to a ... the fold-back current limiting has to deal with latch-up I. INTRODUCTION issues after an overload condition [12-14]. A low drop-out voltage regulator (LDO) dissipates ...
Terms matched: 2 - Score: 21 - 1,362k
Year: 2022, Volume: 22, Number: 1
... test conditions (1000 W/m2 and 25 C). A 250 kW load is inserted between buses 1 and 2. Fig. 1 Figure 3. ... Jahan et al., "Primary frequency regulation of the hybrid power system by deloaded PMSG-based offshore wind farm using centralised droop controller," The Journal of Engineering ...
Terms matched: 2 - Score: 21 - 1,648k
Year: 2015, Volume: 15, Number: 3
... important source of aerodynamic noise of 4 2 f m In the case of a loaded induction motor, the expression for 1 This paper was supported by the Sectoral ... (L WA) [dB] for asynchronous squirrel cage three-phase induction motors at no-load conditions, required by IEC 60034-9. TABLE I. MAXIMUM LEVELS OF WEIGHTED ...
Terms matched: 2 - Score: 21 - 1,513k
Year: 2010, Volume: 10, Issue: 3
... to inject a three phase current into the power supply in order to compensate the load harmonic current, the reactive power A. First order filter and load current ... based on voltage source inverter topology are widely used to improve power quality of nonlinear loads at the point of common coupling to the network. The switching devices of ...
Terms matched: 2 - Score: 21 - 891k
Year: 2015, Volume: 15, Number: 1
... bill intelligence consumer electrical devices. Malfunctioning means and predict and optimize the energy distribution load any deviation of a household device from its normal operating patterns. Instead, ... make an ways of signal processing needed to determine various types analysis process. of workload for the analyzed device. The authors of [11] Starting from this ...
Terms matched: 2 - Score: 20 - 771k
Year: 2021, Volume: 21, Number: 3
... like IPERF and D-ITG to analyze the functionality of operate as switches, firewalls, load balancers, etc. POX the POX controller for the SDN environment. The ... FTB Interface (NBI) API [4]. SDN devices use numerous traffic loads, but with more hardware resources utilization. approaches to controller-based networking that should ...
Terms matched: 2 - Score: 20 - 1,665k
Year: 2022, Volume: 22, Number: 1
... to maintain viability of the aircraft missions, the necessary calculations flight to support the payload using solar panels as a primary and simulations are carried out considering the most ... the platform and the assess the feasibility of their deployment in a given location, payloads. where, the energy generation and consumption are the main While many research ...
Terms matched: 2 - Score: 18 - 1,960k
Year: 2013, Volume: 13, Number: 4
... through a variable resistor method. Another possible method is to use a DC electronic load (eload) such as in [20-21]. The proposed semi-automated system ... testing and monitoring the performance of PV module in outdoor conditions, Figure 2. Interface for PV-TM system hereafter indicated as PV-TM (Testing and Monitoring), is ...
Terms matched: 2 - Score: 18 - 995k
Year: 2017, Volume: 17, Number: 2
... Fig. 2, the following blocks were used: torque; T L €“ load torque; Ω m €“ mechanical rotor angular SM €“ synchronous motor; speed ... F CCd €“ transfer function of the current controller in d-axis; The PMSM is loaded by an induction machine. The inertia F CCq €“ transfer function of the ...
Terms matched: 2 - Score: 18 - 2,573k