569 results found.
Year: 2015, Volume: 15, Number: 4
... the interface by emulating high As mentioned above, the scanning process generates two traffic loads. This was implemented by sending a continuous files, both containing a 3D ... model reconstruction is afterwards architectures, Virtual prototyping, Virtual reality, Web available for download. services. We propose two major improvements over the traditional scanning solutions, ...
Terms matched: 2 - Score: 5 - 1,262k
Year: 2012, Volume: 12, Number: 1
... and kernel IBM, Intel). Major GPU vendors included OpenCL needs to be loaded and built. Kernel object should be built specification support in software development kits ... . Vidal, R. Roy, and F. Bertrand, "A parallel workload balanced and V. CONCLUSION memory efficient lattice-Boltzmann algorithm," Computers& Fluids ...
Terms matched: 2 - Score: 5 - 647k
Year: 2012, Volume: 12, Number: 1
... ) HIL fidelity test setup with the controller simultaneously controlling both the real 2-level inverter-induction motor-load system, and HIL emulator b) comparison of real hardware and HIL inverter ... high Conference, ser. Lecture Notes in Computer Science, 2003 performance electronic hardware-in-the-loop drive-load-simulation [9] D. Majstorovic, I. Celanovic, N. Teslic ...
Terms matched: 2 - Score: 5 - 1,031k
Year: 2011, Volume: 11, Number: 4
... Subsequently, after the first T C clock cycle ends, the counter waits to load the adder output value, depending on the presynaptic activity. The membrane potential ... . datapath operation cycles. The control unit consists of a The reversible counter with loading facilities was master counter, denoted MC, and a Moore finite state preferred ...
Terms matched: 2 - Score: 5 - 490k
Year: 2015, Volume: 15, Number: 4
... the control system stopped accelerating and formance of YILDIZ with these simulation models. the load current decreased from 58 A to 38 A as shown on Considering the SOC ... 1210 s as seen on SEV model. Accordingly, a range model could be uploaded Fig. 12(a) and Fig. 12(b). ...
Terms matched: 2 - Score: 4 - 1,358k
Year: 2015, Volume: 15, Number: 3
... between Figure 1. Model of the observed system. lines to neutral [21]. Values of amplitudes of voltage and Equipment under test (EUT) is load connected via cable current surges delivered by CWG in open circuit and short S-EUT at one socket of single power line. Due to continuous circuit are 6kV and ...
Terms matched: 1 - Score: 156 - 1,482k
Year: 2017, Volume: 17, Number: 3
... Advances in Electrical and Computer Engineering Volume 17, Number 3, 2017 Decoupled Speed and Torque Control of IPMSM Drives Using a Novel Load Torque Estimator Mohamed ZAKY1,2 *, Ehab ELATTAR2, Mohamed METWALY2 1 Department of Electrical Engineering, Northern Border University, Arar,1321, Saudi Arabia 2 Department of Electrical Engineering ...
Terms matched: 1 - Score: 156 - 2,714k
Year: 2017, Volume: 17, Number: 4
... frequency exceeds 20kHz, noise is eliminated, filters are unidirectional switches with FETs and diodes. The converter smaller and efficiency is higher. The current waveform is much load contains the R 0 resistance and the L 0 inductance, and better, the output voltage can be higher than the input voltage C 0 is the output ...
Terms matched: 1 - Score: 84 - 1,545k
Year: 2015, Volume: 15, Number: 2
... , Radha SANKARARAJAN SSN College of Engineering, Chennai-603110 hemalathar@ssn.edu.in 1 Abstract €” Wireless sensor networks (WSNs) are hardly in energy available and to supply the load power during the need of an additional source of power other than the normally period without solar power or when there is any shortage in used batteries, to ...
Terms matched: 1 - Score: 62 - 953k
Year: 2014, Volume: 14, Number: 4
... 10]. To deliver application. Results presented under a wide speed range and the rated power in the event of a single phase failure, five- different load levels show that it is feasible to diagnose such phase motors have to be over-rated only by 25% [11], faults in their early stage, ...
Terms matched: 1 - Score: 57 - 869k