| 2/2011 - 14 |
DSP Based Control Implementation of an AC/DC Converter with Improved Input Current DistortionWISUTMETHEEKORN, P.   , CHUNKAG, V. |
Extra paper information in    |
| Click to see author's profile in SCOPUS, IEEE Xplore, Web of Science |
Download PDF  (873 KB) | Citation | Downloads: 2,875 | Views: 5,944 |
Author keywords
AC/DC converter, converter, digital control, digital signal processing chip, power factor correction
References keywords
power(17), factor(9), control(7), correction(5), mode(4), discontinuous(4), digital(4), conduction(4), boost(4)
Blue keywords are present in both the references section and the paper title.
About this article
Date of Publication: 2011-05-30
Volume 11, Issue 2, Year 2011, On page(s): 87 - 94
ISSN: 1582-7445, e-ISSN: 1844-7600
Digital Object Identifier: 10.4316/AECE.2011.02014
Web of Science Accession Number: 000293840500014
SCOPUS ID: 79958780942
Abstract
This paper presents a digital signal processor based control of an AC/DC converter with nearly unity power factor. Normally, the output voltage of a single-phase AC/DC converter comprises a voltage ripple with twice line-frequency. This affects the voltage control loop and leads to the converter input current distortion. The purposed method is designed to avoid the effect of the output voltage ripple. To verify the proposed control method, MATLAB/Simulink is used for system simulation. A hardware prototype is setup. A low cost digital signal processing chip dsPIC30F4011 is employed as a digital controller to control a CUK AC/DC converter. The converter specifications are 48V output voltage and 250W output power. From the simulation and the experimental results shown that the input current distortion of the purposed system is reduced and lower than the AC/DC converter that controlled by the conventional proportional-integral controller. |
| References | | | Cited By «-- Click to see who has cited this paper |
| [1] K. de Gusseme, D. M. Vande Sype, A. P. Van den Bossche, J. A. Melkebeek, "Digitally controlled boost power-factor-correction converters-operating in both continuous and discontinuous conduction Mode," IEEE Trans. Industrial Electron., vol. 52, no. 1, pp. 88-97, Feb. 2005. [CrossRef] [Web of Science Times Cited 130] [SCOPUS Times Cited 170] [2] K. de Gusseme, W. R. Ryckaert, D. M. Vande Sype, J. A. Ghijselen, J. A. Melkebeek, and L. Vandevelde, "A boost PFC converter with programmable harmonic resistance," IEEE Transaction on Industry Application, vol. 43, no. 3, pp. 742-750, May-June 2007. [CrossRef] [Web of Science Times Cited 19] [SCOPUS Times Cited 22] [3] Ye, Z. Z., M. M. Jovanovic, "Implementation and performance evaluation of DSP based control for constant frequency discontinuous conduction mode boost PFC front end," IEEE Trans. Industrial Electron., vol 52, no. 1, pp. 98-107, Feb. 2005. [CrossRef] [Web of Science Times Cited 62] [SCOPUS Times Cited 92] [4] W. Zhang, Y. Fei Liu, and B. Wu, " A new duty cycle control strategy for power factor correction and FPGA implementation," IEEE Trans. Power Electron, vol. 21, no. 6, pp. 1745-1753, Nov. 2006. [CrossRef] [Web of Science Times Cited 53] [SCOPUS Times Cited 75] [5] G. Venkatesan, R. Arumugam, "Power Factor Improvement in Switched Reluctance Motor Drive," Advances in Electrical and Computer Engineering, vol. 10, no. 1, pp. 59-62, 2010. [CrossRef] [Full Text] [Web of Science Times Cited 4] [SCOPUS Times Cited 4] [6] W. Zhang, G. Feng, Y. F. Liu, and W. Bin, "A digital power factor correction (PFC) control strategy optimized for DSP," IEEE Trans. Power Electron., vol. 19, no. 6, pp. 1474-1485, Nov. 2004. [CrossRef] [Web of Science Times Cited 150] [SCOPUS Times Cited 218] [7] C. Petrea, "Digital Control of Boost PFC Converter Working in Discontinuous Conduction Mode," Advances in Electrical and Computer Engineering, vol. 7, no. 2, pp. 16-19, 2007. [CrossRef] [Full Text] [Web of Science Times Cited 6] [8] Jakab, Lasz1o, Szekely, Sandor, "Remote Supervision System Serving Telecom Network and Power Supply Menagement," in Proc. INTELEC 1987, pp.405-412. [CrossRef] [9] O. García, J.A. Cobos, R. Prieto, P. Alou and J. Uceda, "Single Phase Power factor correction: A survey," IEEE Trans. Power Electron., vol. 18, pp. 749-755, May 2003. [CrossRef] [Web of Science Times Cited 469] [SCOPUS Times Cited 607] [10] S. Buso, P. Mattavelli, L. Rossetto, and G. Spiazzi, "Simple digital control improving dynamic performance of power factor preregulators," IEEE Trans. Power Electron., vol. 18, no. 5, pp. 814-823, Sep. 1998. [CrossRef] [Web of Science Times Cited 171] [SCOPUS Times Cited 207] [11] A. Prodic, D. Maksimovic, and R. W. Erickson, "Dead-zone digital controllers for improved dynamic response of low harmonic rectifiers," IEEE Trans. Power Electron, vol. 21, no. 1, pp. 173-181, Jan. 2006. [CrossRef] [Web of Science Times Cited 62] [SCOPUS Times Cited 81] [12] E. Figueres , J. M. Benavent , G. Garcera and M. Pascual "A control circuit with load-current injection for single-phase power-factor-correction rectifiers," IEEE Trans. Ind. Electron., vol. 54, pp. 1272, June 2007. [CrossRef] [Web of Science Times Cited 38] [SCOPUS Times Cited 53] [13] V. Chunkag and U. Kamnarn, "Parallelling three-phase AC to DC converter using CUK rectifier modules based on power balance control technique," IET Power Electron., vol. 3, pp. 511-524, July 2010. [CrossRef] [Web of Science Times Cited 27] [SCOPUS Times Cited 35] [14] A. Fernandez, J. Sebastian, P. Villegas, M. M. Hernando and D. G. Lamar, "Dynamic limits of a power - factor preregulator," IEEE Trans. Industrial Electron., vol. 52, no. 1, pp. 77-87, Feb. 2005. [CrossRef] [Web of Science Times Cited 36] [SCOPUS Times Cited 47] [15] D. S. L. Simonetti, J. Sebastian, F. S. dos Reis, and J. Uceda, "Design criteria for SEPIC and CUK converters as power factor preregulators in discontinuous conduction mode," in Proc. IEEE PEMC Conf., 1992, pp. 283-288, 1992. [CrossRef] [Web of Science Times Cited 76] Web of Science® Citations for all references: 1,303 TCR SCOPUS® Citations for all references: 1,611 TCR Web of Science® Average Citations per reference: 81 ACR SCOPUS® Average Citations per reference: 101 ACR TCR = Total Citations for References / ACR = Average Citations per Reference We introduced in 2010 - for the first time in scientific publishing, the term "References Weight", as a quantitative indication of the quality ... Read more Citations for references updated on 2024-11-16 11:24 in 112 seconds. Note1: Web of Science® is a registered trademark of Clarivate Analytics. Note2: SCOPUS® is a registered trademark of Elsevier B.V. Disclaimer: All queries to the respective databases were made by using the DOI record of every reference (where available). Due to technical problems beyond our control, the information is not always accurate. Please use the CrossRef link to visit the respective publisher site. |
Copyright ©2001-2024
Faculty of Electrical Engineering and Computer Science
Stefan cel Mare University of Suceava, Romania
All rights reserved: Advances in Electrical and Computer Engineering is a registered trademark of the Stefan cel Mare University of Suceava. No part of this publication may be reproduced, stored in a retrieval system, photocopied, recorded or archived, without the written permission from the Editor. When authors submit their papers for publication, they agree that the copyright for their article be transferred to the Faculty of Electrical Engineering and Computer Science, Stefan cel Mare University of Suceava, Romania, if and only if the articles are accepted for publication. The copyright covers the exclusive rights to reproduce and distribute the article, including reprints and translations.
Permission for other use: The copyright owner's consent does not extend to copying for general distribution, for promotion, for creating new works, or for resale. Specific written permission must be obtained from the Editor for such copying. Direct linking to files hosted on this website is strictly prohibited.
Disclaimer: Whilst every effort is made by the publishers and editorial board to see that no inaccurate or misleading data, opinions or statements appear in this journal, they wish to make it clear that all information and opinions formulated in the articles, as well as linguistic accuracy, are the sole responsibility of the author.
Faculty of Electrical Engineering and Computer Science
Stefan cel Mare University of Suceava, Romania
All rights reserved: Advances in Electrical and Computer Engineering is a registered trademark of the Stefan cel Mare University of Suceava. No part of this publication may be reproduced, stored in a retrieval system, photocopied, recorded or archived, without the written permission from the Editor. When authors submit their papers for publication, they agree that the copyright for their article be transferred to the Faculty of Electrical Engineering and Computer Science, Stefan cel Mare University of Suceava, Romania, if and only if the articles are accepted for publication. The copyright covers the exclusive rights to reproduce and distribute the article, including reprints and translations.
Permission for other use: The copyright owner's consent does not extend to copying for general distribution, for promotion, for creating new works, or for resale. Specific written permission must be obtained from the Editor for such copying. Direct linking to files hosted on this website is strictly prohibited.
Disclaimer: Whilst every effort is made by the publishers and editorial board to see that no inaccurate or misleading data, opinions or statements appear in this journal, they wish to make it clear that all information and opinions formulated in the articles, as well as linguistic accuracy, are the sole responsibility of the author.
