| 2/2014 - 7 |
Modeling, Simulation and Control of Wind Energy Conversion System based on Doubly Fed Induction Generator and CycloconverterBOUMASSATA, A.   , KERDOUN, D. |
Extra paper information in    |
| Click to see author's profile in SCOPUS, IEEE Xplore, Web of Science |
Download PDF  (1,138 KB) | Citation | Downloads: 1,303 | Views: 5,032 |
Author keywords
cycloconverter, doubly fed induction generator, maximum power point tracking, wind energy conversion system
References keywords
power(30), wind(19), energy(19), control(18), systems(10), induction(9), doubly(9), generator(8), dfig(8), system(7)
Blue keywords are present in both the references section and the paper title.
About this article
Date of Publication: 2014-05-31
Volume 14, Issue 2, Year 2014, On page(s): 43 - 48
ISSN: 1582-7445, e-ISSN: 1844-7600
Digital Object Identifier: 10.4316/AECE.2014.02007
Web of Science Accession Number: 000340868100007
SCOPUS ID: 84901840378
Abstract
In this paper, we propose a wind energy conversion system (WECS) at variable speed using a doubly fed induction generator (DFIG) controlled on the rotor side through a cycloconverter. The dynamic behavior of the WECS, including the models of the wind turbine, the DFIG, the cycloconverter, and the power control of this system, is investigated. The power control of this system is applied to achieve the independent control of the active and reactive powers exchanged between the wind generator and the grid. In addition, a maximum power point tracking (MPPT) control is included in the control system to capture the maximum power from the wind. Moreover, the cycloconverter with DFIG are used to test the possibility to operate in two quadrant modes (sub-synchronous and super-synchronous modes). The description of the proposed system is presented with the detailed dynamic modeling equations. The simulation results are presented, to demonstrate the performance and the efficiency of this system. |
| References | | | Cited By «-- Click to see who has cited this paper |
| [1] V. C. Ganti, B. Singh, S. K. Aggarwal, and T. C. Kandpal, "DFIG-based wind power conversion with grid power leveling for reduced gusts," IEEE Trans. On Sustainable energy, vol. 3, no. 1, January 2012. [CrossRef] [Web of Science Times Cited 77] [SCOPUS Times Cited 114] [2] A. Tapia, G.Tapia, J. X. Ostolaza and J. R. Saenz, "Modeling and control of a wind turbine driven doubly fed induction generator," IEEE Trans. On Energy conversion, vol. 18, no. 2, June 2003. [CrossRef] [Web of Science Times Cited 543] [SCOPUS Times Cited 796] [3] M. Tazil, V. Kumar, R.C. Bansal, S. Kong, Z.Y. Dong, W. Freitas and H.D. Mathur, "Three-phase doubly fed induction generators: an overview," IET Electric power applications, vol. 4, pp 75-89, 2010. [CrossRef] [Web of Science Times Cited 164] [SCOPUS Times Cited 220] [4] H. S. Kim and D. D. Chuan Lu, "Review on wind turbine generators and power electronic converters with the grid-connection issues," Universities power engineering conference (AUPEC), 20th Australasian, 1-6, 2010. [5] F. Iov, M. Ciobotaru and F. Blaabjerg, "Power electronics control of wind energy in distributed power systems," Optimization of electrical and electronic equipment, 11th International conference, 2008. [CrossRef] [SCOPUS Times Cited 24] [6] H. Li, Z. Chen and J. K. Pedersen, "Optimal power control strategy of maximizing wind energy tracking and conversion for VSCF doubly fed induction generator system," Power electronics and motion control conference, IPEMC, 2006. [CrossRef] [7] D. Aouzellag, K. Ghedamsi and E.M. Berkouk, "Network power flux control of a wind generator," Renewable energy J 2009, 34:615-622. [CrossRef] [Web of Science Times Cited 27] [SCOPUS Times Cited 46] [8] K. Ghedamsi and D. Aouzellag, "Improvement of the performances for wind energy conversions systems," Electrical power and energy systems J 2010, 32: 936-945. [CrossRef] [Web of Science Times Cited 60] [SCOPUS Times Cited 80] [9] A. K. Chattopadhyay, "Cycloconverters and cycloconverter-fed drives: A review," J. Indian Inst. Sci., vol. 77, pp 397-419, Sep-Oct. 1997. [10] S. Miyazawa, F. Nakamura and N. Yamada, "Effective approximation suitable for the control algorithm of microprocessor based cycloconverter," IEE Proceedings., vol.135, Pt.B, no. 3, May 1988. [CrossRef] [11] F. Poitiers, T. Bouaouiche and M. Machmoum, "Advanced control of a doubly-fed induction generator for wind energy conversion," Electric power systems research J 2009, 79:1085-1096. [CrossRef] [Web of Science Times Cited 159] [SCOPUS Times Cited 246] [12] F. Hachicha and L. Krichen, "Rotor power control in doubly fed induction generator wind turbine under grid faults," Energy J 2012, 44: 853-861. [CrossRef] [Web of Science Times Cited 40] [SCOPUS Times Cited 46] [13] M. V. Kazemi, A. S. Yazdankhah and H. M. Kojabadi, "Direct power control of DFIG based on discrete space vector modulation," Renewable energy J 2010, 35:1033-1042. [CrossRef] [Web of Science Times Cited 60] [SCOPUS Times Cited 74] [14] N. Taib, B. Metidji and T. Rekioua, "Performance and efficiency control enhancement of wind power generation system based on DFIG using three-level sparse matrix converter," Electrical power and energy systems J 2013, 53: 287-296. [CrossRef] [Web of Science Times Cited 19] [SCOPUS Times Cited 31] [15] L. Zhang, C. Watthanasarn "A matrix converter excited doubly-fed induction machine as a wind power generator," IET, 7th international Conference on power electronics and variable speed Drives, 532-537, 1998. [CrossRef] [16] H. Altun, S. Sunter, "Modeling, simulation and control of wind turbine driven doubly-fed induction generator with matrix converter on the rotor side," Springer, Electr. Eng., 95:157-170, 2013. [CrossRef] [Web of Science Times Cited 25] [SCOPUS Times Cited 32] [17] T. Nakano, H. Ohsawa, and K. Endoh, "A high-performance cycloconverter-fed synchronous machine drive system," IEEE Trans. On Industry Applications, vol. IA-20, no. 5, 1984. [CrossRef] [Web of Science Times Cited 28] [SCOPUS Times Cited 52] [18] Y. Liu, G. T. Heydt and R.F. Chu, "The power quality impact of cycloconverter control strategies," IEEE Trans. On Power delivery, vol. 20, no. 2, April 2005. [CrossRef] [Web of Science Times Cited 50] [SCOPUS Times Cited 79] [19] M. Boutoubat, L. Mokrani and M. Machmoum, "Control of a wind energy conversion system equipped by a DFIG for active power generation and power quality improvement," Renewable energy J 2013, 50:378-386. [CrossRef] [Web of Science Times Cited 104] [SCOPUS Times Cited 137] [20] C. Y. Tang, Y. Guo and J. N. Jiang, "Nonlinear dual-mode control of variable-speed wind turbines with doubly fed induction generators," IEEE Trans. On Control Systems Technology, vol. 19, no. 4, July 2011. [CrossRef] [Web of Science Times Cited 54] [SCOPUS Times Cited 68] [21] A.A. El-Sattar, N.H. Saad and M.Z. Shams El-Dein, "Dynamic response of doubly fed induction generator variable speed wind turbine under fault," Electric power systems research J 2008, 78:1240-1246. [CrossRef] [Web of Science Times Cited 58] [SCOPUS Times Cited 76] [22] A. Gaillard, "Systeme eolien base sur une MADA: contribution a l'etude de la qualite de l'energie electrique et de la continuite de service," PhD thesis, University of Henri Poincare, Nancy-I, 30 April 2010. [23] D. Kairous and R. Wamkeue, "DFIG-based fuzzy sliding-mode control of WECS with a flywheel energy storage," Electric power systems research J 2012, 93:16-23. [CrossRef] [Web of Science Times Cited 37] [SCOPUS Times Cited 48] [24] A. M. Kassem, K. M. Hasaneen and A. M. Yousef, "Dynamic modeling and robust power control of DFIG driven by wind turbine at infinite grid," Electrical power and energy systems J 2013; 44; 375-382. [CrossRef] [Web of Science Times Cited 69] [SCOPUS Times Cited 90] [25] Y. Bekakra and D. Ben Attous, "Sliding mode controls of active and reactive power of a DFIG with MPPT for variable speed wind energy conversion," Australian journal of basic and applied sciences, vol. 5, no. 12, pp. 2274-2286, 2011. [26] L. Jerbi, L. Krichen and A. Ouali, "A fuzzy logic supervisor for active and reactive power control of a variable speed wind energy conversion system associated to a flywheel storage system," Electric power systems research J 2009, 79:919-925. [CrossRef] [Web of Science Times Cited 58] [SCOPUS Times Cited 85] [27] A. Gaillard, P. Poure, S. Saadate, M. Machmoum, "Variable speed DFIG wind energy system for power generation and harmonic current mitigation," Renew Energy J 2009; 34:1545-1553. [CrossRef] [Web of Science Times Cited 82] [SCOPUS Times Cited 116] Web of Science® Citations for all references: 1,714 TCR SCOPUS® Citations for all references: 2,460 TCR Web of Science® Average Citations per reference: 61 ACR SCOPUS® Average Citations per reference: 88 ACR TCR = Total Citations for References / ACR = Average Citations per Reference We introduced in 2010 - for the first time in scientific publishing, the term "References Weight", as a quantitative indication of the quality ... Read more Citations for references updated on 2024-11-18 18:09 in 159 seconds. Note1: Web of Science® is a registered trademark of Clarivate Analytics. Note2: SCOPUS® is a registered trademark of Elsevier B.V. Disclaimer: All queries to the respective databases were made by using the DOI record of every reference (where available). Due to technical problems beyond our control, the information is not always accurate. Please use the CrossRef link to visit the respective publisher site. |
Copyright ©2001-2024
Faculty of Electrical Engineering and Computer Science
Stefan cel Mare University of Suceava, Romania
All rights reserved: Advances in Electrical and Computer Engineering is a registered trademark of the Stefan cel Mare University of Suceava. No part of this publication may be reproduced, stored in a retrieval system, photocopied, recorded or archived, without the written permission from the Editor. When authors submit their papers for publication, they agree that the copyright for their article be transferred to the Faculty of Electrical Engineering and Computer Science, Stefan cel Mare University of Suceava, Romania, if and only if the articles are accepted for publication. The copyright covers the exclusive rights to reproduce and distribute the article, including reprints and translations.
Permission for other use: The copyright owner's consent does not extend to copying for general distribution, for promotion, for creating new works, or for resale. Specific written permission must be obtained from the Editor for such copying. Direct linking to files hosted on this website is strictly prohibited.
Disclaimer: Whilst every effort is made by the publishers and editorial board to see that no inaccurate or misleading data, opinions or statements appear in this journal, they wish to make it clear that all information and opinions formulated in the articles, as well as linguistic accuracy, are the sole responsibility of the author.
Faculty of Electrical Engineering and Computer Science
Stefan cel Mare University of Suceava, Romania
All rights reserved: Advances in Electrical and Computer Engineering is a registered trademark of the Stefan cel Mare University of Suceava. No part of this publication may be reproduced, stored in a retrieval system, photocopied, recorded or archived, without the written permission from the Editor. When authors submit their papers for publication, they agree that the copyright for their article be transferred to the Faculty of Electrical Engineering and Computer Science, Stefan cel Mare University of Suceava, Romania, if and only if the articles are accepted for publication. The copyright covers the exclusive rights to reproduce and distribute the article, including reprints and translations.
Permission for other use: The copyright owner's consent does not extend to copying for general distribution, for promotion, for creating new works, or for resale. Specific written permission must be obtained from the Editor for such copying. Direct linking to files hosted on this website is strictly prohibited.
Disclaimer: Whilst every effort is made by the publishers and editorial board to see that no inaccurate or misleading data, opinions or statements appear in this journal, they wish to make it clear that all information and opinions formulated in the articles, as well as linguistic accuracy, are the sole responsibility of the author.
