591 results found.
Year: 2019, Volume: 19, Number: 3
... pp. 253-260, October 2018. 1, WOSIS, 2005, pp. 239-252. doi:10.5220/0002580202390252 https://energetics.cosrec.org/wp-content/uploads/2019/03/eNergetics- [19] K. Scarfone, P. Mell, "Guide to Intrusion Detection and Prevention 2018.pdf Systems (IDPS ...
Terms matched: 1 - Score: 3 - 274k
Year: 2019, Volume: 19, Number: 3
... to scheduling dependencies may scale better on a higher core load/store values from a shared DPRAM but it ... partial reconfiguration of the FPGA. Special units can be loaded and unloaded as needed by the 1 This work ... partly been funded by Thüringer Aufbaubank TAB and algorithm, changing the configuration of the soft-core as EFRE under grant ...
Terms matched: 5 - Score: 40 - 358k
Year: 2019, Volume: 19, Number: 3
... "BalanceFlow: (pps) (ms) Controller load balancing for OpenFlow networks," in 2012 IEEE ... Available: http://archive.openflow.org/wp/downloads/. [Accessed 16 2017]. November ... this B. HPOFS Architecture mechanism, memory could be overloaded and is the weakness of this approach. LineSwitch ...
Terms matched: 3 - Score: 10 - 672k
Year: 2019, Volume: 19, Number: 2
... simulation results are indicated and performed under different weather and load conditions. discussed in the fifth section. Finally ... sources. However, RESs were not to support sensitive loads such as communication buildings reliable and cost-effective sources to ... and the speed of global can be changed under variable loading conditions to warming [3]. Not only ...
Terms matched: 4 - Score: 116 - 1,822k
Year: 2019, Volume: 19, Number: 2
... determine recloser power distribution systems. A performance analysis of load cluster priorities, it is proposed to consider statistical ... the maximum of average number of consumer units. Critical loads are also considered peak currents in the period from ... a.m. to 7 p.m. exceeds the as a decision factor in the cluster choice. current of 600 ...
Terms matched: 3 - Score: 54 - 1,192k
Year: 2019, Volume: 19, Number: 2
... viscous friction, Te and Tl are the motor and load g) The switch gate signal (g) ... the current controllers and the three control signals using The no-load and short-circuit tests are used to obtain the ( ... separately excited DC generator is coupled with the IM for loading tests. Cuk converter consists of a switch, ...
Terms matched: 5 - Score: 46 - 1,610k
Year: 2019, Volume: 19, Number: 2
... The IM are exposed to different applications to identify one and two BRB s in steady state mechanical, magnetic, electrical, and thermal stimulus, with also different load levels. In [7 ], authors use a which frequently could cause failures [1]. From all possible combination of a filter bank and the ...
Terms matched: 1 - Score: 28 - 1,378k
Year: 2019, Volume: 19, Number: 2
... system performance. PSO optimized PID controllers are hybrid MG system during intermittent conditions of load and used in D-FACTS. generation. In addition, a comparative study of ... optimization, particle swarm optimization (PSO) and experimental validation is made using pulsed loads. A grid the PSO with new update mechanism (PSOd) are used ...
Terms matched: 2 - Score: 67 - 1,471k
Year: 2019, Volume: 19, Number: 2
... , switching frequency, and [6] A. Ayed, Tr. Dubois, J. L. Levant, and G. Duchamp, "A New method load capacitance. This dependency is clearly depicted by the for the characterization of electronic components immunity," IEEE measurement results in Fig. 19. Note that the ...
Terms matched: 1 - Score: 5 - 1,450k
Year: 2019, Volume: 19, Number: 2
... are the III. INDUCTION MOTOR DESIGN applied armature voltage and current, ω is the angular rotor A. Theory speed in rad/s, TL is the load torque, Pi and Po are the input and output powers, Pm is the electromechanical power, PCu The field oriented control (FOC) with short circuited ...
Terms matched: 1 - Score: 6 - 1,202k