267 results found.
Year: 2013, Volume: 13, Number: 4
... by the target cell libraries width(ns) 0.215 0.219 0.206 0.074 m0 m1 Fault type '0' '0' '0' '0' and the types of logic ... denote a region of the driving power for the individual logic gate. The propagation faulty site (typically, the drain area of the MOSFET) of gate delay ...
Terms matched: 2 - Score: 15 - 827k
Year: 2013, Volume: 13, Number: 3
... in Table I, are considered. There are no faults during the operating. Figure 5. Phase portrait ... Microgrid and its basic equations are Besides that, a fault of an inverter does not cause a collapse described ... . The model includes the most Stability Characterization Subsequent to Fault-Triggered Islanding important dynamics. The no-linear model can find ...
Terms matched: 3 - Score: 10 - 704k
Year: 2013, Volume: 13, Number: 3
... with less or even no need for the consideration of speech envelope is extracted to estimate a coarse time delay its geometry and location information; it has a certain fault first, and then the accurate time delay is searched for within tolerance, i.e. the failure of the individual microphone will a certain range near the coarse ...
Terms matched: 1 - Score: 3 - 757k
Year: 2013, Volume: 13, Number: 3
... identify massive simulation experiments have fully proven that the system faults. fault identification can be performed successfully by Index ... Computer Engineering Volume 13, Number 3, 2013 New Fault Discrimination under the Influence of Rayleigh Noise Yagang ZHANG ... and seeking after for the uniform laws of category and non-fault category will be explored. In the electrical quantities ...
Terms matched: 4 - Score: 226 - 632k
Year: 2013, Volume: 13, Number: 3
... in the Linux kernel is Scheduler (CFS) [18-19]. The general Linux kernel as its an integer number between 0 to 139. The priority number default scheduler employs this scheduler. Thus, it is also from 0 to 99 are reserved for real-time class tasks. Tasks used in OSs for PCs and even ...
Terms matched: 1 - Score: 15 - 929k
Year: 2013, Volume: 13, Number: 2
... can substitute another consideration of the abnormal comportments and the faults failed equipment or element, one can speak about ... uses converters must be realized by using high reliability the fault tree method. Based on the symptoms observed in ... ", Advances in Electrical and Computer Engineering Topology With Fault-Tolerant Ability", IEEE Trans. Power Volume 12 ...
Terms matched: 4 - Score: 268 - 716k
Year: 2013, Volume: 13, Number: 2
... of cryptographic algorithms [17]. Further then the transmitter can send up to 50 blocks per second. on, some solutions incorporate a very complicated With a default block size of 512 bytes, the transfer rate is authentication system that uses a time synchronization bounded to 25 kB/s [1 ][ 10] ...
Terms matched: 1 - Score: 3 - 908k
Year: 2013, Volume: 13, Number: 1
... . However, the weak at this situation. Therefore small error in the difference between the results begins to increase along with calibration of the torque transducer can cause faulty in the the increase of the current value. In FE simulations, B-H measurements, especially at low torque conditions. 79 Advances in Electrical and Computer Engineering ...
Terms matched: 1 - Score: 3 - 649k
Year: 2012, Volume: 12, Number: 4
... many times assumed in three-phase power systems. In tested during the cold war, they can estimate a parameter of reality, most voltage dips occur due to unbalanced faults, interest one-step-ahead based on the previously observed which introduce different values of voltage for each phase values. Two filters are implemented. Their performance is and phase ...
Terms matched: 1 - Score: 3 - 794k
Year: 2012, Volume: 12, Number: 4
... ), Volume 206/ 2011, Part 7, [6] M. Merah, A. Ouamri, A. Nait-Ali, M. Keche, "Fault Tolerant Neural pag. 481-487, Springer-Verlag Berlin Heidelberg 2011, Network for ECG Signal Classification Systems", Advances in [24] G. Antoniol, P ...
Terms matched: 1 - Score: 3 - 608k