600 results found.
Year: 2013, Volume: 13, Number: 4
... see Fig. 2) from max € Fig. 2b min circuit Fig. 2b Minimum 100 250 MAX €“ finding the maximum value; on odd clock Maximum frequency in MHz value b) MAX_MIN €“ finding maximum and minimum value; cycle N € 5 a) N/4 items EVEN_ODD €“ data sort by circuits ...
Terms matched: 1 - Score: 20 - 698k
Year: 2010, Volume: 10, Issue: 1
... then used in the distance determination formula. The tests were made in a 3 meters semi-anechoic chamber- in order the results not to be affected by other radio frequency emissions from the surrounding environment- using a 20 Hz- 26.5 GHz EMI Test Receiver, a log-periodic antenna and RF Figure 1. Experimental test setup for ...
Terms matched: 1 - Score: 20 - 680k
Year: 2009, Volume: 9, Issue: 3
... simulation results, faults can be detected and signal. Wavelet technique analyzes signals in time and identified as soon as fault appears. In summary, if the system frequency domains and gets the results to describe the has a fault diagnosis structure, system dangerous situations can be avoided. character of the signals. The paper is ...
Terms matched: 1 - Score: 20 - 516k
Year: 2015, Volume: 15, Number: 4
... both purposes. A problem can be identified when using corresponding data must be computed under 10 µs for a metallic coils because the temperature sensors required are 100kHz switching frequency. This is why the resistance reference is computed on a PC in order to minimize the 1 unnecessary processing load. This work was supported by a grant ...
Terms matched: 1 - Score: 19 - 1,502k
Year: 2021, Volume: 21, Number: 2
... db8) to models is summarized in the range of 4.1ms to 7.91ms detect voltage sag/swell with and without positive/negative under different conditions. The sampling frequency was phase jumps. The performance of this method with respect 6.66kHz. This technique was also used in a benchmark to accuracy and detection time is better than ...
Terms matched: 1 - Score: 19 - 1,483k
Year: 2021, Volume: 21, Number: 4
... to reduce interference that can be applied, but the standards have not yet been and extend network coverage in D2D communications. defined for all 5G protocols. Higher frequency bands, from NARA uses a graph coloring approach to model the problem 3.5 GHz (GHz) to at least 26 GHz, have a higher capacity, ...
Terms matched: 1 - Score: 19 - 1,835k
Year: 2010, Volume: 10, Issue: 1
... L1 D3 current. The selection of inductor value is based on Duty 400V DC R2 D5 C8 cycle (D ), input voltage (Vin), switching frequency (fs) and C2 R1 0 €“ 160V DC C4 C1 change in current( I). The inductance is given by, Q2 D2 C7 Vin ...
Terms matched: 1 - Score: 19 - 427k
Year: 2014, Volume: 14, Number: 4
... faults are also troublesome [14]. over conventional three-phase motors, including reduced There is a growing interest in the analysis of multiphase torque ripple amplitude with higher frequency, reduced motors during fault operation. For example, [11] analyzes phase currents at the same phase voltage, therefore reducing the change in machine losses ...
Terms matched: 1 - Score: 19 - 869k
Year: 2012, Volume: 12, Number: 4
... the filter's stability Dash et al [8] have used the same Extended Kalman Filter using the Jury' stability criterion (presented as well). Section for frequency measurement. They demonstrate that the IV presents the theory behind the Kalman filter. The two frequency and amplitude can be estimated in the same time. filters ...
Terms matched: 1 - Score: 19 - 794k
Year: 2009, Volume: 9, Issue: 2
... ] (2) 100 100 100δ KC p was based on the hybrid engine built in our laboratory. The number of phases is denoted by m1, the frequency of II. EQUIVALENT CIRCUITS supply voltage by f1 (in [Hz]), the number of coils on phase By analogy with the characteristics of asynchronous ...
Terms matched: 1 - Score: 19 - 1,515k