591 results found.
Year: 2012, Volume: 12, Number: 1
... result from the combination of pulses, for a common load of composed of four individual rectangular pulses, of ... first stage, subsequent device. the capacitor will be loaded by the M1 transistor with a This fact occurs ... the delaying time period only, when current denoted by I, and the second stage will find the the ...
Terms matched: 4 - Score: 27 - 651k
Year: 2012, Volume: 12, Number: 1
... and kernel IBM, Intel). Major GPU vendors included OpenCL needs to be loaded and built. Kernel object should be built specification support in software development kits ... . Vidal, R. Roy, and F. Bertrand, "A parallel workload balanced and V. CONCLUSION memory efficient lattice-Boltzmann algorithm," Computers& Fluids ...
Terms matched: 2 - Score: 5 - 647k
Year: 2012, Volume: 12, Number: 1
... ) HIL fidelity test setup with the controller simultaneously controlling both the real 2-level inverter-induction motor-load system, and HIL emulator b) comparison of real hardware and HIL inverter ... high Conference, ser. Lecture Notes in Computer Science, 2003 performance electronic hardware-in-the-loop drive-load-simulation [9] D. Majstorovic, I. Celanovic, N. Teslic ...
Terms matched: 2 - Score: 5 - 1,031k
Year: 2012, Volume: 12, Number: 1
... emulated by means 7. The front end modulates the information and transmits of a load. This is required if we want to verify the maximum it back to ... be added. As shown in the simulations -by sensortec.com/content/language1/downloads/BST-BMA222-DS002- applying the Friis formula- the achieved range would be 02.pdf ...
Terms matched: 2 - Score: 8 - 851k
Year: 2011, Volume: 11, Number: 4
... behavior of the system. The impact of the maximum power point (MPP) current and voltage variations due to luminosity changes is determinate, as well as the load variation. The stability of the system is analyzed using the state transition matrix over one switching cycle (the monodromy matrix) including the state transition matrices during ...
Terms matched: 1 - Score: 24 - 1,333k
Year: 2011, Volume: 11, Number: 4
... has raised many important questions partly due to the very Manufacturing (2) Item load into a case Facility broad range of envisaged applications ([ 4 ], ... question is: "Will introduction of RFID result in substantial (7) Pallet unload in the retail store Retail Store (8) Unpacking of a pallet gains ...
Terms matched: 2 - Score: 15 - 1,343k
Year: 2011, Volume: 11, Number: 4
... different. One of them has rectifier bridge and a load resistance. There are also a few 12 inset ... and Propulsion Conference, VPPC, pp. 819-830, Under-Load Operation with Imposed Conditions of a New Hybrid 2005 ... Synchronous Generator", Bul. Inst. Polit. IaŸi, Tomul LI (LV), Fasc. ...
Terms matched: 3 - Score: 14 - 888k
Year: 2011, Volume: 11, Number: 4
... Subsequently, after the first T C clock cycle ends, the counter waits to load the adder output value, depending on the presynaptic activity. The membrane potential ... . datapath operation cycles. The control unit consists of a The reversible counter with loading facilities was master counter, denoted MC, and a Moore finite state preferred ...
Terms matched: 2 - Score: 5 - 490k
Year: 2011, Volume: 11, Number: 3
... the DFT, cannot be parallel active filter (PAF) is used to compensate load 31 Advances in Electrical and Computer Engineering Volume 11, Number 3, 2011 ... of the signal. The phase-locked loop (PLL) is used for the varying loads in the electric power system is widespread and synchronisation of the algorithm based on ...
Terms matched: 2 - Score: 59 - 803k
Year: 2011, Volume: 11, Number: 3
... performing stateful translation, we did not consider stateless and decapsulation of IPv6 datagrams into IPv4 datagrams as translators in our research, and we will use the term their payload. The IPv6 header remains intact, but a new "NAT64 translation" to refer to stateful NAT64 translation IPv4 header is formed and used on the way ...
Terms matched: 1 - Score: 32 - 1,160k