400 results found.
Year: 2021, Volume: 21, Number: 2
... difficult the full decomposition. A diagonal operating cost, [2-3], [14]. quadratic approximation method produces an approximated A generic software for ED problems estimates the optimal block separation of the penalty term, so that the ED model is value of power to be generated with the least possible fuel decomposed into several ...
Terms matched: 1 - Score: 3 - 1,584k
Year: 2021, Volume: 21, Number: 3
... for some values of μ. Hence, considering the design of ƒ ƒƒ our LCSQ for the particular variance, we can conclude that In this case, we estimate SQNR as: one should better use the exact formulas, defined with (19) ƒ 2 ƒ SQNR() € 10 log10 ƒ ƒ. ...
Terms matched: 1 - Score: 3 - 1,269k
Year: 2009, Volume: 9, Issue: 1
... , we carried out additionally time- often. domain measurements for getting the real traffic situation The rms E-field averaged values dependence on BI was that enables a realistic estimate of the exposure level. analyzed. The field was measured at a distance of 140cm The measurement of the E-field distribution in the room from the AP in ...
Terms matched: 1 - Score: 3 - 536k
Year: 2009, Volume: 9, Issue: 1
... . "An RF Electronically Controlled Impedance Tuning Network Design [4] W. M. Frix and G. G. Karady, "A Circuital Approach to Estimate the and Its Application to an Antenna Input Impedance Automatic Magnetic Field Reduction of Nonferrous Metal Shields," IEEE Matching System," IEEE Transactions on Microwave Theory ...
Terms matched: 1 - Score: 3 - 1,121k
Year: 2013, Volume: 13, Number: 3
... Nm (i.e. from 5.03% to 0.98% of the rated torque). The coercitive magnetic field strength of PMs. rated torque (RT) was estimated at approximately 2.1 Nm. The material properties of the SPM machine are the following: standardized magnetic steel laminations M600- IV. IMPACT OF STATOR CORE STRUCTURE ...
Terms matched: 1 - Score: 3 - 885k
Year: 2016, Volume: 16, Number: 3
... modelling application, the fuzzy model structure involves the following choices [20]: (a) input and output variables: The essential of this problem is to estimate the glucose concentration ratio (%) of aqueous solutions having different concentrations by using a measured data set. For this aim, three input variables which ( ...
Terms matched: 1 - Score: 3 - 1,193k
Year: 2013, Volume: 13, Number: 3
... of specific core loss from the In order to find motor efficiency, air-friction loss must be defined table and for the value Bm,i of magnetic induction. estimated because it cannot be calculated through the FEM Now, from the equations (13), (14), (15) and (18), ...
Terms matched: 1 - Score: 3 - 876k
Year: 2021, Volume: 21, Number: 3
... temperature-dependent reaction rate, electrolytes, and current collectors. Then, the various αa, αc is the symmetry factor, Ce, Cs are lithium governing equations were estimated for the 2D structure of concentration in the solid and electrolyte phase and Csurf, max, the model for a better understanding of the ionic/ electronic Csurf ...
Terms matched: 1 - Score: 3 - 1,304k
Year: 2021, Volume: 21, Number: 2
... until convergence. V. SIMULATION RESULTS We present the simulation results of our proposed MOOP optimization in this section. The convergence performance of our proposed algorithms is also estimated through simulation results. We consider that the RRHs with two antennas (U= 2) are fixed in a square grid. The number of Figure 2 ...
Terms matched: 1 - Score: 3 - 1,348k
Year: 2009, Volume: 9, Issue: 2
... cylinder of compressor. By using of a linear oscillating motor, the transverse forces are not generated and the corresponding friction losses are reduced towards zero. It is estimated an improving in efficiency with 5% that results in electricity savings of 30% on the global refrigerator. This saving is very important if we take in ...
Terms matched: 1 - Score: 3 - 473k