555 results found.
Year: 2016, Volume: 16, Number: 2
... presented in this paper also can be considered in DVCC. The total noise voltage at Y ports is the combination of thermal noises of NMOS differential pairs and PMOS loads. IV. SIMULATION RESULTS So, transistors M3, M4, M7 and M8 give rise to the thermal To verify theoretical approach presented in the previous noise ...
Terms matched: 1 - Score: 3 - 1,830k
Year: 2016, Volume: 16, Number: 2
... , semi-paired and semi-supervised datasets cannot be analyzed directly because the high generalized correlation analysis (S2GCA)[16], semi- dimensionality of data can make data overload, and some supervised canonical correlation analysis based on label data mining algorithms non applicable in these propagation (LPbSCCA)[6] are proposed. datasets[ ...
Terms matched: 1 - Score: 2 - 1,513k
Year: 2016, Volume: 16, Number: 2
... is not connected to the inverter, the extracted current is imposed by the dummy load and the DC bus voltage is maintained at 420V or higher. When the ... 5. It can be seen that the feedforward loop because of the connected dummy loads. When switch S1 can be easily disabled by setting the VRMS (8 ...
Terms matched: 2 - Score: 8 - 1,666k
Year: 2016, Volume: 16, Number: 1
... parameter values in the no- conclude that, when the assumptions detailed above are load regime and the ones determined experimentally (see taken into account, the essential ... other, an analysis of the impedance (ZR). This implies that the no-load impedance two-port parameters for the unidirectional circuit diagram is (Ze10), and ...
Terms matched: 2 - Score: 40 - 849k
Year: 2016, Volume: 16, Number: 1
... L, jxT k ], ZL is the complex load switchable maximized-gain beampatterns in underlay spectrum sharing. We ... same size and circuit and the passive elements are reactively loaded. comparable number of elements. In addition, ... two different beampattern shapes of ESPAR antenna, and reactive loads on the passive elements, and the vector v ...
Terms matched: 4 - Score: 40 - 1,236k
Year: 2016, Volume: 16, Number: 1
... to interface renewable energy sources and port, and the load as output port. FLC is implemented to the ... changing the insolation of the two PV ports under constant loaded condition. To verify the operation of the DO ... the total power produced by the two PV ports was fixed around 555 W such that the PV port 1generated ...
Terms matched: 3 - Score: 88 - 1,854k
Year: 2016, Volume: 16, Number: 1
... on GPSO for the wide speed range and for different load component for steady-state operation. An adaptive algorithm conditions ... extended back-EMF algorithm [31]. The IPMSM is loaded with MAGTROL HD-705-7 brake. PL [W] ... d) energy efficiency difference between two methods for different loads at 8 krpm Figure 14. Block diagram of ...
Terms matched: 4 - Score: 90 - 1,367k
Year: 2016, Volume: 16, Number: 1
... be an important way to reduce That is, relay load is uniformly allocated to CHs in each overhead in ... . This is because these around the sink have larger loads than those farther away sensor nodes must forward the ... this work. A proper node deployment scheme prevents the overloading of CHs around the sink. strategy has proven ...
Terms matched: 3 - Score: 34 - 1,201k
Year: 2016, Volume: 16, Number: 1
... urban driving cycle and is intended to 396 48 1000 60.1268 represent city driving conditions. It is characterized by low 396 38.4 800 59.0657 vehicle speed and low engine load. The Extra Urban Driving 396 41.6 900 58.3103 Cycle (EUDC) has been designed to represent more 396 48 1100 55.942 396 38.4 900 54.7941 aggressive driving ...
Terms matched: 1 - Score: 3 - 1,239k
Year: 2016, Volume: 16, Number: 1
... , in the same time, having the highest capacitive load €“ References [24-25] are taking profit also ... x € ƒ— e jƒ— ƒ—x For a heavily capacitively loaded transmission line, A major difference between (7 ... 3, the model for the 2D configuration starts clock loads. G S represents the effect of the uniformly ...
Terms matched: 6 - Score: 149 - 1,444k